AMD Geode

From JookWiki
Revision as of 09:55, 12 February 2022 by Jookia (talk | contribs) (Put board specifications back down)

I have a board with an AMD Geode CPU for some light retrocomputing development. This page details it and whatever I get up to with it.

Motivation

For a while I've been searching for a small computer with these requirements:

  • Runs real mode DOS programs
  • Has a somewhat antiquated CPU
  • Has an Ethernet card and DOS packet driver
  • Doesn't consume too much power

The use case here is to run my Twitch DOS Bot I've been developing over the years.

After the searching I found that there were a few systems that could approximate this:

  1. A Raspberry Pi running DOSBox-X
  2. Thin client machines that used VIA CPUs
  3. Expensive single-board computers using a Vortex86 chip
  4. Cheaper 86Duino boards
  5. An old Eee PC 1000HA I had

I eventually decided to go with option 1, a Raspberry Pi emulating DOS.

At least, until I saw an offer on eBay: a used Advantech PCM-9375F for only $50 AUD, which is over $400 less than new.

Why such a huge discount? Video output is broken. Which means you can't really do much with this machine. This at minimum would let me run by Internet-connected DOS bot and talk to DOS over a serial port.

I've also not had an x86 board with GPIO before, so that seems like something fun to play with.

I bought it on November 7 2021 and received it on November 12 2021.

See AMD Geode/Troubleshooting for details on the troubleshooting process.

See AMD Geode/Video 1 for details on the troubleshooting video production.

Board specifications

The PCM-9375 A3 specifications shows these points that interest me:

  • AMD Geode LX800 500 MHz CPU (see the AMD Geode LX Processors Data Book for more information)
  • AMD Geode CS5536 chipset (see the AMD Geode CS5536 Companion Device Data Book for more information)
  • Dual RTL8139 10/100 Mbps Fast Ethernet (second requires breakout board that I have)
  • 5V power supply (12V needed for optional LCD)
  • CompactFlash storage
  • 3 RS-232 serial interfaces (only the main serial interface is given a port)
  • 8 GPIO pins (you don't see x86 boards with GPIO often)
  • No nopl instruction support

Note that the IDE connector on the board is 2.0mm pitch, not the standard 2.54mm pitch most IDE cables use.

TODO: Look at board again and validate and clarify these specifications.

Setup

TODO: rename this maybe?

- USB power

- CompactFlash

- Null Modem Cable

- Serial ports