Latest revision |
Your text |
Line 6: |
Line 6: |
|
| |
|
| I decided in early May 2023 to scrap the voice-over and just put some music over it. This managed to get the video released. | | I decided in early May 2023 to scrap the voice-over and just put some music over it. This managed to get the video released. |
|
| |
| == Video explanation ==
| |
| I filmed this almost of the video as a continuos 6 hour session, with 4 hours being soldering. This was not a good idea. In fact, the entire video is filled with almost entirely bad ideas.
| |
|
| |
| Here's a broad listing of takeaways you should have:
| |
|
| |
| * Don't solder for more than an hour at a time
| |
| * Take breaks when you're frustrated
| |
| * Perform each action with a plan and stop if it fails
| |
|
| |
| I failed almost all of these and instead tried to brute force through the process. Trying to continue a project that requires thought and attention after burning through those 15 minutes in did not work.
| |
|
| |
| Specific mistakes in the video:
| |
|
| |
| * I used too large a tip for most of it
| |
| * I removed an imperfect pad instead of soldering on to it
| |
| * I didn't use my too small pad strips as I thought running wire would be easier
| |
| * I didn't tin the copper pads I made
| |
| * I tried to use overcoat to bond pads to the board
| |
| * I wanted to use tape to hold the pads down while heating but I didn't cut it too size and lifted the new pads
| |
| * I spent way too long setting the pads and adding epoxy
| |
| * I didn't remove the wire enamel before soldering
| |
| * I didn't tape down the inductors and wires while soldering
| |
| * I went around to 'touch up' random joints without a plan
| |
| * I used the wrong iron shape to touch up the network IC joints
| |
| * I couldn't get a solder blob to flow and added braid instead, creating more thermal mass
| |
|
| |
| Things I actually did well in the video:
| |
|
| |
| * I cleaned up the flux mess as I went
| |
| * I fixed the VGA port
| |
| * I used nail polish to coat the exposed network IC pins
| |
|
| |
| Mistakes outside of the video:
| |
|
| |
| * I misplaced the SMD capacitors I was going to solder
| |
|
| |
| I think I learned a lot. I felt really bad about having this video to show for it, but I think I did okay all things considered.
| |
|
| |
|
| == Overall progress == | | == Overall progress == |
Line 53: |
Line 15: |
| *Editing: Cut the video down to an appropriate size | | *Editing: Cut the video down to an appropriate size |
| *Editing: Added music and rendered | | *Editing: Added music and rendered |
| *Wiki: Video explanation | | |
| | === To-do === |
| | *Video explanation, scrapped script |
|
| |
|
| === Postponed for part 3 === | | === Postponed for part 3 === |